Sealing Access To The Balance Settings - OHAUS PAJ603 Manual De Instrucciones

Pioneer™
^^^^^^^^^^^^^^^^^^^^^
User ID: ............................
Bal ID: 123456789
Proj ID: ...........................
Time: ......:.......:.......
Date: ...../ ..... / .....
120.01 g
^^^^^^^^^^^^^^^^^^^^^
4.7 RS232 Menu [.rs232.]
Baud [BAUD] - The RS232 baud rate can be set to 600, 1200, 2400, 4800, 9600 and 19200.
Parity [Parity] - Parity can be sent to 7 bits-even parity [7 eveN], 7bits-odd parity [7 odd], 7bits-no parity [7
No] or 8bit-no parity [8 No].
Handshake [Handsh] - Handshake can be set to off [set Off], X on – X off [on-off], or hardware [HardwWr].
4.8 Lock Menu [.LOC.]
When a Lock Menu item is set on the indicated menu cannot be changed.
[Loc Cal] - Calibration, [Loc SEt] - Setup, [Loc.mMod] - Mode, [Loc.Unit] - Unit,
[Loc Prt] - Print, [Loc 232] - RS232

4.9 Sealing Access to the Balance Settings

The Menu Lock switch prevents changes to the Lock Menu. The switch can be secured using paper seals, wire seals
or plastic ties.
Un-Locked
4.11 Approved "M" Models
Balances marked with an "M" have been calibrated and sealed at the factory for use as an EEC approved balance.
The Cal, Setup, Mode and Unit menus will be locked.
4.12 Local Approval
The InCal models can be approved by local weights and measures authorities. The calibration must be verified and
the Menu settings must be set appropriately before being locked using the Lock Menu. The Menu Lock switch on
the bottom of the balance can then be sealed in the locked position. The supplied capacity label is to be placed below
the display.
Multi Line Format with 4 line feeds
Line Feed-2
Line Feed-3
Line Feed-4
GLP (ON)
Balance ID (ON)
GLP (ON)
GLP (ON)
GLP (ON)
Result
Locked with Plastic Tie
EN-6