General Description; Operation; Locking The Spray Gun; Pressure Relief Procedure - Titan IMPACT 400 Manual Del Propietário

General Description

This airless sprayer is a precision power tool used for spraying
many types of materials. Read and follow this instruction manual
carefully for proper operating instructions, maintenance, and safety
information.
This pump is available in a stand model (0532000) and a cart model
(0532001).
Some of the graphics in this manual may not exactly match your
sprayer and spray gun. All information and instructions given in this
manual applies to all models except where noted.
1
2
3
4
5
12
13
9*
k
PRIME
SPRAY p
Item Description
1
Motor
2
Pressure control knob
3
Oil cup
4
Outlet fitting
5 Filter
6 Siphon tube
7 Return hose
8 ON/OFF switch
9 PRIME/SPRAY valve
10
Drip cup (stand model only)
11
Pail bracket (cart model only)
12
Liquid Shield™ (4 oz.)
13
Piston Lube™ (4 oz.)
English
6
7
8
9*
10
11
4

Operation

This equipment produces a fluid stream at extremely
high pressure. read and understand the warnings
in the Safety Precautions section at the front of this
manual before operating this equipment.
ImPOrTaNT: The vents in the bottom and rear of the motor
shroud are designed to keep the motor from getting excessively
hot during operation. make sure the vents in the bottom and
rear of the motor shroud are not covered or obstructed.

Locking the Spray Gun

1. To lock the trigger, rotate the trigger lock forward until it
stops.
2. To unlock the trigger, rotate the trigger lock backwards until it
is vertical.
Trigger locked (gun
will not spray)

Pressure relief Procedure

Be sure to follow the Pressure relief Procedure when
shutting down the sprayer for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for
cleanup.
1. Lock the gun by turning the gun trigger lock to the locked
position.
2. Move the PRIME/SPRAY valve down to the PRIME position.
3. Turn off the sprayer by moving the ON/OFF switch to the OFF
position.
4. Set the pressure to minimum by turning the pressure control
knob fully counterclockwise.
5. Unlock the gun by turning the gun trigger lock to the
unlocked position.
6. Hold the metal part of the gun firmly to the side of a metal
container to ground the gun and avoid a build up of static
electricity.
7. Trigger the gun to remove any pressure that may still be in the
hose.
8. Lock the gun by turning the gun trigger lock to the locked
position.
Trigger unlocked
(gun will spray)
© Titan Tool Inc. All rights reserved.