Elettro LEM1238 Instrucciones De Uso página 13

BATTERY CHARGER ITEM 623 – LEM1270
BEFORE USING YOUR BATTERY CHARGER READ WARNINGS AND INSTRUCTIONS CAREFULLY
This charger is designed to charge various types of 12 Volt lead batteries (for example WET, GEL, AGM
etc.), widely used in cars, motorcycles and other kind of vehicles, with capacity range from 14 Ah to 150 Ah at
12V. Do not charge different types of batteries or faulty batteries.
Protection rating IP65 against external agents.
Not suitable to supply power to a low voltage electrical system.
Do not use for any other purpose.
1. TECHNICAL SPECIFICATIONS
Input power supply
Absorbed power
Input current
Cut off voltage
Charging current
Back Drain Current
Ripple
Type of battery
Protection class
Noise
Operating temperature
Internal fuse
2. LUMINOUS SIGNALLING
Signal
LED ON (Red)
LED 12V ON (Red)
LED 13.6V/SUPPLY blinking
LED 13.6V/SUPPLY ON
LED 16V BOOST ON (Red)
LED 16V BOOST regular blinking
LED 16V BOOST irregular blinking
LED ON (red)
LED 25% blinking (red)
LED 25% ON;
LED 50% blinking (red)
LED 25%, 50% ON
Led 75% blinking (yellow)
LED 25%,50%,75% ON
LED 100% blinking (green)
LED 25%,50%,75%,100% ON
220-240V AC 50/60Hz
135W
1.2 A RMS. Max
14.4 +/-0.25 or 13.6 +/- 0.5
7.0A +/- 10% or 3.5A +/- 10% or 5.0 A +/-10% or 1.5 A +/-
0.5 A
<5mA (No AC input)
150mV Max
Lead 12V: 14Ah - 225Ah
IP65
<50dB (tests carried out at 500mm)
0 - +40° C
2.5A/250V
Condition
Mode STANDBY
Mode 1
Mode 2
Mode 2 power supply
Mode 3 BOOST
BOOST process
BOOST completed
Reversed polarity
Charging (below 25%)
Charging (below 50%)
Charging (below 75%)
Charging (below 100%)
Fully charged
13
Remarks
Standby
Mode 12V (14.4V - 7.0A)
Mode 12V (13.6V - 5.0A),
maintenance.
Mode 12 V (13.6V - 5.0A),
Supplying 13.6V
Mode 12V, BOOST 16V - 1.5A
BOOST process
BOOST completed
Reverse the polarity
Charging (below 25%)
Charging (below 50%)
Charging (below 75%)
Charging (below 100%)
Fully charged, in maintenance