Environmental Conditions - Sunrise Medical JAY Fit Manual Del Usuario

E N G L I S H
P. POSTURAL SUPPORT ACCESSORIES
DANGER!
When using Removable, adjustable, or hinged components:
1. Check the function of all moveable component
accessories that may be added to this device.
2. Ensure that these items are fully adjusted and locked
into position to provide the necessary support to the
user.
3. Items such as swing-away laterals, abductors, and head
supports are an important to the safety and health of the
user and must be checked regularly to make sure they
have not moved or been left unlocked accidentally.
• If you fail to heed these warnings damage to your
wheelchair, a fall, tip-over or loss of control may occur
and cause severe injury to the rider or others.
Q. ENVIRONMENTAL CONDITIONS
CAUTION!
Contact with water or excess moisture may cause your
wheelchair to rust or corrode. Avoid all extreme weather
situations if possible.
• Do not use your components in a shower, pool or other
body of water. The parts are not water-tight and may
rust or corrode from the inside.
• Avoid excess moisture (for example, do not leave your
wheelchair in a damp bathroom while taking a shower).
• Dry your components as soon as you can if they get wet,
or if you use water to clean them.
Jay Fit Back
G E N E R A L WA R N I N G S
R. JAY™FIT BACK TRANSIT SAFETY
DANGER!
JAY™Fit back has been dynamically tested for use in a
motor vehicle. This system conforms with ANSI/RESNA-
WC 19 and ISO Standard 7176-19. If JAY™Fit back is
to be used in a transit situation, it must be mounted to a
wheelchair that conforms to the performance requirements
of ANSI/RESNA- WC 19 and ISO Standard 7176-19.
For Rider safety, Please follow all installation, use, and
maintenance instructions within this manual as well as the
transit instructions listed below:
• If possible and feasible, the rider should transfer to the
Original Equipment Manufacturer vehicle seat and use
the vehicle restraints.
• The distance between the top of the user's shoulder and
the top of the back should not exceed 6.5" (16.5 cm).
• The wheelchair must be labelled as appropriate for
use as a seat in a motor vehicle, dynamically tested to
the performance requirements of ANSI/RESNA- WC
19 and ISO Standard 7176-19 and installed, used and
maintained according to the manufacturer's instructions.
• If the original wheelchair seat was replaced, the new
seat must be approved for wheelchair transit, installed
and used as indicated in the manufacturer's instructions.
• The Wheelchair Tie-down and Occupant Restraint
System (WTORS) should be compatible with the specific
wheelchair, used as indicated in the manufacturer's
instructions and should comply with the performance
requirements of ISO Standard 10542.
• The Wheelchair must be forward facing during transport.
• If you fail to heed these warnings damage to your chair,
a fall, tip-over or loss of control may occur and cause
severe injury to the rider or others
11
Rev.D