Removal And Replacement - Sunrise Medical JAY Fit Manual Del Usuario

E N G L I S H
I N S TA L L AT I O N A N D A D J U S T M E N T
K. MOUNTING AN OPTIONAL HEADREST
Fig.19.0
The Jay Fit Back has a universal headrest plate (N)
N
mounted to it. Care should be taken to use the proper screw
length when mounting.
L. SECURE THE FOAM AND COVER TO THE SHELL
To secure the back foam and cover on the Jay Fit Back,
slide the top edge of the cover over the top lip of the shell.
Press the back in place against the shell, pull the two button
snaps under the bottom of the shell and snap to the buttons.
M. REMOVAL AND REPLACEMENT
Following installation and adjustment, the back can be easily
removed from the wheelchair if necessary. Simply twist the
quick release brackets (H - Fig.16.0), out of the way on both
sides and lift the back up and out of the chair.
To replace, lower the stud nuts into the lower receiver
assembly until it rests against the upright posts. Twist the
quick release brackets down over the top hooks on the
back.
The back will retain angle adjustment when removed and
replaced on the wheelchair.
18
Jay Fit Back
Rev.D