REMIS REMIfront IV-M Instrucciones De Montaje página 17

C15
C16
C17
C18
C19
C20
C15:
Connect the two tubes with the tube
NOTICE!!!
bearing by pushing the free tube ends
on the grub screw. To do so, care-
fully bend the guiding tubes into the desired position, if
necessary. The position of the tube bearing should now be
approx. 10mm away from the dashboard's light edge (see
C15).
Screw the tube holder onto the dashboard. To do so, use
the 4.2x13mm (black) countersunk bolt. In case the tubes
are not in line with the tube bearing, turn them out a bit
from the tube holder inside the A-pillar facing.
C16+C17:
Place the top shields by pushing them outside in the
provided nut of the A-pillar. In the middle, the two shields
are connected with the grub screw and the two M4 nuts
(C17). Make sure the grub screw is placed in the middle of
the shields.
Also make sure that the outlines of
NOTICE!!!
the shield towards the plastic part
located between the headlining and
the navigation box, have an even distance.
C18:
Place the shields at the edge of the headlining (transition
to the screen) and pre-drill at the designated spots using a
Ø6.5mm drill.
C19+C20:
Screw the shields to the headlining using the 12.5x23
screw dowels.
US/GB
17/60