Carrera RC Nintendo Mini Mario-Copter Instrucciones De Montaje Y De Servicio página 20

• Switch on the controller at the ON/OFF
switch. Be sure to check the Beginner-Ad-
vanced switch (
13b
stick, i.e. the throttle lever, right to the top,
then fully downwards into the zero position.
• Allow the Quadrocopter a few moments un-
til the system is correctly initialised and is
ready for operation. The LED in the Quadro-
copter now lights continuously. The LED on
the controller now lights continuously.
• Repeat the above points as required, if you wish
to fly more Quadrocopters at the same time.
• Important note! Please perform the au-
to-trimming before each flight without
17
fail!
• Check the control system.
• Make yourself familiar with the control system.
• Trim the Quadrocopter as necessary as
described under
hovering it no longer moves from the spot
without a command from the controller.
• The Quadrocopter is now ready to be flown.
• If the Quadrocopter displays no functions,
retry the above binding procedure.
• Fly the model.
• Land the model.
• Switch the model off at the ON/OFF switch
• Disconnect the battery plug connection.
• Always switch off the remote control last.
Flying the 4-channel Quadrocopter
NOTE! Take care particularly in the first
few flights to move the lever on the con-
troller very gently and not over-hurriedly.
As a rule, only very small movements of
the respective levers are necessary to car-
ry out the desired control commands!
If you notice that the Quadrocopter moves
forwards or to the side without your touching
the respective lever, please adjust the trim of
the Quadrocopter as described in
+/- Gas (up / down)
9
To start or to fly higher, push the gas le-
ver on the left cautiously forwards. To land
or fly lower, push the gas lever on the left
cautiously backwards.
ENGLISH
). Push the left-hand joy-
, so that when
17 18 19 20
17
18 19 20
10
To make the Quadrocopter circle to the left
or the right on the spot, move the lever on
the left cautiously to the left or the right.
11
To fly the Quadrocopter to the left or the
right, push the lever on the right cautiously
to the left or the right.
12 To fly the Quadrocopter forwards or back-
wards, push the lever on the right cautious-
ly forwards or backwards.
Start the rotors and motors
13 a Press the 'Start rotors' button on the
controller, in order to start the motors.
You can lift the throttle control upwards as
soon as the rotors are running.
Beginner/Advanced switch
WARNING!
100 % IS ONLY FOR EXPERIENCED PILOTS!
13 b 30% = beginner mode
Signal sounds once on switching over.
60% = medium mode
The quadrocopter reacts more sensitively
than in 30 % mode. Signal sounds twice
on switching over.
100% = Advanced Modus -> 3D Modus
The Quadrocopter reacts very sensitive-
ly to joystick movements. Signal sounds
three times on switching over.
Automatic control of altitude
14 The Quadrocopter will maintain the cur-
rent flying altitude automatically as soon
as you release the left-hand joystick dur-
ing the flight.
.
20