EN
INSTRUCTIONS
13
refittinG tHe 5-Point
Harness sYsteM and coVer
a. after washing, place the cover
on seat and pass buckle latches
with belt through cover slot
at the both sides of seat, then
insert cover alongside the edge
of seat.
B. take the harness buckle and
hold the metal plate vertically.
Push it with the narrow side
upwards through the belt slot to
the seat shell from above, then
rotate it to the position as shown
in right pictures.
c. Pass harness straps through
shoulder pads and insert them
into harness slots, then connect
the end of strap with metal
connectors.
d. also pass the end of the
shoulder pads strap through
the harness strap slot and shell,
then fix into the strap yoke.
Make sure the straps can not be
rotated.
e. close the buckle, then fasten
the cover all around. check that
it works!
Clic k