Troubleshooting - Franklin Chef FIM400 Manual Del Usuario

Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this manual
first. If the problem persists, check the Troubleshooting Guide below and on the following page.
The problem could be something very simple that can be solved without a service call.
Problem
The machine doesn t
operate.
Water doesn t feed in
after the ice maker starts.
Machine makes ice cubes,
but ice storage bin does
not fill up with ice.
Water is leaking from the
unit.

Troubleshooting0000000

Troubleshooting
Possible cause
The ice maker is
unplugged.
The fuse is blown.
The ice maker power
switch is OFF.
The ice storage bin is full
of ice.
The water tap is turned off.
The water supply line is not
connected properly.
Condenser may be dirty.
The air flow to the ice
maker may be obstructed.
The ambient and water
temperatures are high, or
the machine is near some
heat source.
A few water drops fall to
the floor when you open
the door to take out ice
from the ice storage bin.
Water supply connection
leaking.
20
Guide0000
Probable correction
Plug the ice maker in.
Replace fuse. If it happens
again, call for service to
check for a short circuit in
the ice maker.
Turn the ice maker power
switch ON.
Remove some ice. Make
sure the water curtain and
microswitch are closed.
Turn on the water supply
tap.
Reconnect the water supply
line.
Clean the condenser air
filter.
Check the installation.
Check the installation.
Normal condensation on
the door or some water
together with ice. Take care
when you take out ice.
Tighten fitting. See
Connecting the water
line .