We thank you for having chosen our company; our product is a great heating solution developed from the most advanced technology
with top quality machining and modern design, aimed at making you enjoy the fantastic sensation that the heat of a fl ame gives, in
complete safety.
The entire range of products is built in compliance with the following Directives:
89/106 EEC (Construction Products), 89/366 EEC (EMC Directive), 2004/108 CE (EMC Directive), 2006/95 CE (Low Voltage
Directive), EN 14785, EN 60335-1, EN 60335-2-102, EN 61000-3-2, EN 61000-3-3, EN 50366, EN 55014-1, EN 55014-2, EN
303 - 5, EN 13240
The boilers produced by our establishment are built with attention
to the individual components in a way to protect both the user
and the installer from any accidents. It is therefore recommended
that after any intervention on the product, that authorised staff
pay particular attention to the electric connections, especially
the stripped parts of the wires. These must not escape from the
terminal board in any situation, thus preventing possible contact
with the live parts of the wire.Installation must be carried
out by authorised staff, who must provide the buyer with a
declaration of conformity for the system and will assume full
responsibility for final installation and as a consequence the
correct functioning of the installed product. It is necessary to
bear in mind all laws and national, regional, provincial and
town council Standards present in the country the appliance
has been installed. The manufacturer cannot be held
responsible for the failure to comply with such precautions.
The instruction manual is an integral part of the product: make
sure that it always accompanies the appliance, even if transferred
to other owners or user or is transferred to another place. If it is
damaged or lost,request another copy from the area technician.
This boiler must be destined for the use for which it has been
expressly realised. The manufacturer is exempt from any liability,
contractual and extracontractual, for injury/damage caused to
persons/animals and objects, due to installation, adjustment
and maintenance errors and improper use. After the packaging
has been removed, check the integrity and completeness of the
contents. If this does not comply, contact the dealer where the
appliance was purchased.All electric components that make up
the boiler must be replaced with original spare parts exclusively
by an authorised after-sales centre, thus guaranteeing correct
functioning. The boiler must be serviced at least once a year,
programming it in advance with qualifi ed staff and/or the
manufacturer's technical after-sales assistance.
For safety reasons, remember that:
The boiler must not be used by persons (including children)
with reduced physical, sensorial and mental capacities or who
are unskilled persons, unless they are supervised and trained
regarding use of the appliance by a person responsible for their
safety.
Children must be controlled to ensure that they do not play
with the appliance.
Do not touch the boiler when you are barefoot or when
parts of the body are wet or humid.
The safety and adjustment devices must not be modifi ed
without the authorisation or indications of the manufacturer.
Do not pull, disconnect, twist electric cables leaving the
28
Congratulations!
WARNINGS AND SAFETY DEVICES
boiler, even if disconnected from the electric power supply
mains.
It is advised to position the power supply cable in a way that
it does not come into contact with hot parts of the appliance.
The power supply plug must be accessible after
installation.
Do not close or reduce the dimensions of the airing vents in
the place of installation. The airing vents are indispensable for
correct combustion.
Do not leave the packaging elements within reach of
children or unassisted disabled persons.
The hearth door must always be closed during normal
functioning of the product.
Avoid direct contact with parts of the appliance that tend
to heat up during functioning.
Check for the presence of any obstructions before switching
the appliance on following a prolonged standstill period.
The boiler has been designed to function in any climatic
condition (also critical). In particularly adverse conditions
(strong wind, freezing) safety systems may intervene that
switch the boiler off . If this occurs, contact the technical after-
sales service and always disable the safety system.
If the fl ue should catch fi re, be equipped with suitable
systems for suff ocating the fl ames or request help from the fi re
service.
This appliance must not be used to burn waste
Do not use any infl ammable liquids for ignition
During the fi lling phase do not allow the bag of pellets to
come into contact with the product
WARNINGS AND SAFETY DEVICES