Bunn FMD-1 Manual De Capacitación Técnica página 118

Dimensions & Specifications
Model Product #
FMD-4 34900.0002
FMD-5 34900.0000
*Power cord (NEMA 5-15P) 15 Amp-120V machine only. **Based on incoming water temperature of 50
Electrical: 120V model requires 2-wires plus ground service rated 120V, single phase, 60 hz. 120/240V model requires
3-wires plus ground service rated 120/208 or 120/240V, single phase, 60Hz.
Plumbing: 20-100 psi (138-690 kPa) from a 3⁄8" or larger supply line. A shut-off valve should be installed in the line
before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied
with 3⁄8" male flare fitting.
18.50
BUNN Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
BUNN practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
®
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
Volts Amps Tank Heater
Watts
120 15 1700
120 15 1700
19.30
FMD-4
SIDE VIEW
21.15
1.50
14.66
Bunn Corporation owns all copyrights relating to materials in this publication. Please contact Bunn Corporation to request permission to reproduce any portion of this publication.
Total Capacity
Watts
1800 4.2 gal/hr**
1800 4.2 gal/hr**
FRONT VIEW
19.30
FMD-5
25.26
29.26
4.00
1.75
ADJ.
Cubic Shipping
Measure Weight Attached
11 ft 118 lbs.
3
11 ft 123 lbs.
3
F/10˚C.
o
BACK VIEW
18.60
17.68
15.68
Cord
Yes*
Yes*