Maintenance And Cleaning; Cleaning The Inside Of The Appliance - FALMEC 110030294 Manual De Instrucciones

H
FILTERS
REMOVING AND REPLACING'S INSTRUCTIONS
1. METAL FILTERS
To remove the metal grease fi lter, open the door carefully as shown in fi g. 2. Use the handle to remove the metal fi lters.
2. CHARCOAL FILTERS
Remove the metal fi lters by following the instructions in section H1.
The two fi lters attached to the right and left hand side of the conveyor can now be easily accessed. See fi gure for assembly/
replacement.
To order new carbon fi lters contact your distributor/dealer.
ONLY FOR ITALY: Download the form to order the fi lter from the website:
www.falmec.com (via the dropdown assistance menu).
I
LIGHTING
ASSEMBLY AND REPLACEMENT
1. LED SPOTLIGHT (Flipper)
In this case the hood is equipped with high efficiency, low power LED spotlights with extremely high durability under normal use
conditions.
2. SPOTLIGHT (Flipper/E)
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
L

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over time. Special attention should be paid to the
metal grease-trapping filters and the charcoal filters. Frequent cleaning of the filters and their supports will ensure that fats and grease
do not accumulate on the range hood, with the consequent risk of fire.
1. METAL ANTI-GREASE FILTERS
Their function is to trap suspended grease particles, accordingly, it is advisable to wash them once a month in hot water and
detergent, without bending them. Leave to dry completely before re-assembling them.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is purified by passing a number of times through
the filters and being recirculated into the kitchen. The charcoal filters cannot be cleaned, and should be replaced on average every 3-4
months (according to use). To replace the charcoal filters, see the instructions in point H2.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid that oily or greasy substances affect the steel
surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using clean with a soft cloth, rinse and wipe dry
thoroughly. Do not use products that contain abrasive substances, rough cloths or cloths specifically designed for cleaning steel.
Using abrasive substances or rough cloths will inevitably damage the finish of steel. The steel surface will be irrevocably damaged if
the instructions above are not complied with. Keep these instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compliance with the instructions above.

4. CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be cleaned using liquids or solvents.
Do not use abrasive products.
All the above operations must be performed after having disconnected the appliance from the mains power supply.
11