HammerSmith 231600 Instrucciones De Uso página 22

Clockwise rotation: For the screwing in of screws,
press the right-hand side of the rotation direction switch
(1) as far as the stopping position. (Illustration 4)
Anti-clockwise rotation: To slacken or to undo screws,
press the left-hand side of the rotation direction switch
(1) as far as the stopping position. (Illustration 4)
Release switch: The release switch (2) is activated by
pushing the switch. To switch off, let go of the switch
again. (Illustration 4)
PLEASE NOTE:
➔ The switch does not operate if the rotation direction switch is set at the centre position.
➔ The switch is an ON/OFF switch. It does not control the speed.
➔ Only place screws in the power tool when switched off. Tool bits can slide about.
LED Work Light
The LED- Work light (1) switches on automatically as soon
as the switch is activated. (Illustration 5). It will switch off
automatically when you release the switch.
Angle Attachment (Optional accessory of the Hammersmith Drill&Screw)
This convenient accessory can be found in our MediaShop Onlineshop
(www.mediashop.tv). If you are an owner of the Hammersmith Drill&Screw
Professional you would have been supplied with this accessory.
The Hammersmith Drill&Screw angle attachment makes flexible use possible for you in
difficult to reach working areas.
1. Remove the rubber-nose cap (1). Tip: Use a supplied
slot-bit in order to make the rubber-nose cap easier to
remove. Slide the bit between the rubber-nose cap and
the front side of the tool casing (2) to make a gap. Now
simply remove the rubber-nose cap. (Illustration 6).
2. Pull the bit (3) out of the magnetic casing.
3. Pull the angle attachment's locking ring (1) back (arrow
illustration 7).
4. Plug the hexagon bolt (2) into the mounting cone (3). (Illustration 7)
5. Slide the angle attachment fully onto the casing and slacken the locking ring.
22
1
2
ill. 4
1
ill. 5
2
3
1
ill. 6