b.
Remove the front and rear deck wheels by removing the flange lock
nuts and shoulder bolts that secure them to the deck. See Figure 9.
c.
Place the deck lift lever in the desired mowing height setting.
d.
Reinsert the shoulder bolt (with each deck wheel) into the index
hole that leaves approximately ½-inch between the bottom of the
wheel and the pavement. Tighten the flange lock nut and shoulder
bolt to between 25-30 ft-lbs using a torque wrench.
NOTE: Refer to Adjusting the Deck in the Maintenance & Adjustments section of
this manual for more detailed instructions regarding various deck adjustments.
Gas and Oil
Fuel Recommendations
Use automotive gasoline (unleaded or low leaded to minimize combustion chamber
deposits) with a minimum of 87 octane. Gasoline with up to 10% ethanol or 15%
MTBE (Methyl Tertiary Butyl Ether) can be used. Never use an oil/gasoline mixture
or dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank. DO NOT use E85
gasoline.
•
Refuel in a well-ventilated area with the engine stopped. Do not smoke or
allow flames or sparks in the area where the engine is refueled or where
gasoline is stored.
•
Do not overfill the fuel tank. After refueling, make sure the tank cap is closed
properly and securely.
•
Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite.
If any fuel is spilled, make sure the area is dry before starting the engine.
•
Avoid repeated or prolonged contact with skin or breathing of vapor.
Adding Fuel
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the riding mower
indoors or while the engine is hot or running. Extinguish cigarettes, cigars,
pipes and other sources of ignition.
Figure 9
WARNING
ASSEMBLY
1.
Be sure engine is outdoors and in a well-ventilated area.
2.
Clean area around the fuel fill cap and remove the fuel fill cap.
3.
Using an approved red GASOLINE container, add fuel slowly, being careful to
avoid spilling.
4.
Fill the tank until the fuel reaches the bottom of the fuel tank neck.
5.
Replace the fuel cap and tighten securely. Wipe up spilled fuel before
starting engine. If fuel is spilled DO NOT start engine. Move riding mower
away from area of spillage. Avoid creating any source of ignition until fuel
vapors are gone.
Checking and Adding Oil
Your riding mower is shipped with oil in the engine. However, you MUST check
the oil level before operating. Check and add the oil as instructed in your Engine
Operator's Manual.
Always check the engine oil level before each use as instructed in the engine
operator's manual. Add oil as necessary. Failure to do so may result in serious
damage to your engine.
Smart Lawn App Bluetooth® Activation
Take command of your lawn care with the Bluetooth® enabled Smart Lawn App
from Craftsman. Maintenance tips, weather tracking and more — everything you
need to keep the best yard on the block is now in one place.
Smart Lawn also provides step-by-step instructions and video tutorials to show
you how to keep your riding mower running right. Plus, you can order the parts you
need directly from the app. The app also tracks the charge of your riding mower
battery, as well as the state of other key replacement components like oil, blade and
air filter.
Connect your Bluetooth® enabled riding mower by downloading the FREE
Craftsman Smart Lawn App to begin using all of the new connectivity features
of your Craftsman rider! Download it for FREE from the App Store or Google Play
(works with devices running iOS 9, Android 4.4 and later versions).
Once you've created your account, the app will prompt you to enter your riding
mower's model number and serial number barcodes. Next it will attempt to connect
with the riding mower via Bluetooth®.
Set your smartphone Bluetooth® setting to the 'ON' position. In order to sync your
phone to the riding mower, turn on the engine, or turn the key to the 'ON' position.
Remember to turn the key to the 'OFF' position after you connect so as not to drain
the battery charge (if not running the riding mower).
If you have further questions, call our Craftsman help line at 1-888-331-4569.
11
CAUTION