Work Pro BlueLine Digital M Guía Rápida página 4

EN
BLS 2
AUDIO IP STREAMER
6
4
BLS 2
LITE
AUDIO IP STREAMER
9
1
1. LAN connector: Use a Cat5 cable to connect the device to the network. The modular devices (BLS 2
& BLS 2M) will be connected through the switch placed inside the modular unit (BL PSU).
2. DC 5V supply: Connect the adequate cable (taking into account the polarity) between each module
and the main supply bank connection in BL PSU.
3. Input audio sources: 1 stereo audio source.
4. Source selector: Use this selector to "name" the audio sources into the network and selected it with the
same number in the receiver.
The selection can be made using this selector of through its webserver (Consult INSTALLATION and
webserver sections).
5. GPIOs: The device incorporate 4 GPI and 4 GPO which state will be reflected in the GPIOs placed in
BLR 2. For example, closing GPI 1 in the BLS 2M will send its state to GPO 1 in BLR 2 and vice versa.
6. Remote connection: NO FUNCTION
7. Alarm: These contacts are used for alarm purpose. Closing its contact causes that ALL receiver connect
channel 1 at 100% of volume.
8. DC 12-24V supply: Connect an adequate external supply to feed the device taking into account the
correct polarity.
NOTE: This devices can be also feed through PoE
9. LINE IN: 2 unbalanced input for auxiliar audio sources.
BlueLine System
LITE
DC-12V/24V
- 3 -
SENDERs
- Independent unit which add 1 stereo
unbalanced channel in the network.
8
- Can coexist with BLM unit, being another
streamer of the same network
- Power supply: PoE and 12V/24V DC (feed
through external power supply)
120 x 95 x 45 mm
455 g
Quick Reference / Guía rápida
BLS 2
LITE