Work Pro BlueLine Digital M Guía Rápida página 9

PREVIOUS NOTE
BlueLine system sends 1 stereo audio source from a streamer (sender) to one or more
receivers. The system requires " to name" each streamer to select at each receiver or receivers
and extract the desired stereo source. This process is performed in 2 ways:
- Manually: Assigning one of the 16 positions with the selector and choosing the same
position in the desired receiver or receivers. This process is easier and faster in systems
with up to 16 streamers.
- Software: Accessing the webserver of streamers and receivers, it is possible to assign the
channel, apart from other advanced features. This method is recommended for large
installations with a greater number of streamers.
GENERAL
1. Using a cat5 cable, connect the device (sender or receiver) to the shared network (through
hub, switch or wallmount socket).
2. Feed each device with the adequate main supply. Check each particular features to select
the adequate one.
3. The LEDs will lit according to their state: Power LED will lit when the unit wil be powered, Link
LED will be lit when the device is connected to the LAN and Act LED will flick sending &
receiving information packages.
SENDERs
1. By default, the streamers are configurated to stream the audio sources in PCM format
(The most common and with a low latency time), Thus, in most of the facilities is not required
to perform any previous configuration (which, in this case, was done through the webserver).
2. With the source selector, select one of the 16 positions in order to identify it in the network
(If the number of sender is over 16, use the webserver to setup it).
3. Connect the adequate audio source.
RECEIVERs
1. With the source selector, select one of the 16 positions. This position must be the same
position set in the streamer from which we want to extract the audio source.
(If the number of sender is over 16, use the webserver to setup it).
NOTE: Several receivers can choose the same streamer.
2. If you need a BLC 1, connect it in the adequeate socket (marked as REMOTE) in order to
control the source and volume locally.
NOTE 1: BLR 2 / BLR 2 LITE and BLR 2A have preamp output. Therefore, their output must
be connected to unbalanced inputs in the amplifier.
NOTE 2: BLR 2A incorporates amplified outputs, therefore, connect the adequate loudspeaker
load according to the main supply: 2x5W (PoE) or 2x15W (external main supply).
BlueLine System
INSTALLATION
- 8 - Quick Reference / Guía rápida
EN