Built-In Printer (Optional Feature); Printing Sample; Paper Feed; Paper - Circutor MD-5060e Guia Del Usuario

Built-in printer (Optional feature)

Printing sample

Paper feed

Key (, a blue button located at the upper-left in the printer body, is the Paper Feed control. Press this button for 3 times
after the end of the test and before to cut the paper, in order to advance the paper sufficiently to keep the last lines.
CAUTION: Do not pull the paper, always use the Paper Feed button. Never pull the paper back. The printer could be easily
damaged by pulling the paper in any direction.

Paper

Battery charger

This apparatus includes a built-in, state-of-the-art device that controls battery charge and power supplied to the apparatus
from the electric supply network.

Battery Charge:

The equipment has a built-in intelligent circuit that controls the battery charge process. The following process has to be
followed to charge the battery:
• Check if switch 1 is off.
• Connect the power supply cable plug into INPUT'.
• After a few seconds, the red indicator LED ? will turn on until charge is complete. When the green LED turns on, it will
remain lit until the unit is disconnected.
Alternate green and red lights
Steady red light
Flashing red light
Steady green light
This printer uses a thermal paper, 37mm wide, in a roll of up to 33mm diameter. Figure
below shows how to insert the paper. Press Key ( until paper appears. To change the
paper roll please cut the paper before it enters inside the printer, and then press the
Paper Feed button (, because the paper movement is uni-directional.
Evaluation of the battery initial status when the source is connected,
during one second.
Battery under charge.
The battery was not successfully charged. It denotes some trouble in the
battery charging process.
The charge has successfully finished. The battery is OK.
33