INFOSEC UPS SYSTEM E3 LCD RT 800 IEC Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Examples of steps to follow for setting the parameters:
Step 1 - Before entering setting mode, make sure that the
UPS is in Stand-by mode (off-charging) and that the battery is
connected. The LCD display is shown as right.
Step 2 - Press and hold the "Selection" button for 5 seconds to
enter Setting mode.
Step 3 - Press the "Up" button (ON/MUTE) to switch to "02" of
program list. Then press "Enter" button to enter value setting of
parameter 2. Press the "Up" button to change the value to
"ENA" to enable the programmable outlet function. Then press
"Enter" button again to confirm the setting.
Step 4 - Press the "Up" button (ON/MUTE) again to switch to
"03" of program list. Then press "Enter" button for setting
programmable outlet time. Push "Up" button to change the
value of backup time according your demand. Then press
"Enter" to confirm the setting.
Step 5 - Press "Up" button (ON/MUTE) to switch to "00" of program list. Then press "Enter" button
to exit setting menu.
Step 6 - Disconnect AC input and wait until the LCD display is off. The new setting will be activated
when turning on the UPS again.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
13
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 01 13 AA 59 209 18

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

E3 lcd rt 1000 iecE3 lcd rt 1500 iecE3 lcd rt 2000 iecE3 lcd rt 2500 iecE3 lcd rt 3000 iecE3 lcd rt 3500 iec ... Mostrar todo

Tabla de contenido