Battery Replacement - INFOSEC UPS SYSTEM E3 LCD RT 800 IEC Manual De Instrucciones


Step 7 - Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect
full battery run capability during this initial charge period.

Step 8 - Install software
For optimal computer system protection, refer to the InfoPower software CD to fully
configure UPS shutdown.

2.4 Battery replacement

NOTICE: This UPS is equipped with internal batteries and user can replace the batteries
without shutting down the UPS or connected loads (hot-swappable battery design).
Replacement is a safe procedure, isolated from electrical hazards.
CAUTION! Consider all warnings, cautions, and notes before replacing batteries.
Note: Upon battery disconnection, equipment is not protected from power outages.

Step 1
Remove front panel.

Step 4
Remove the top cover of
battery box and replace the
inside batteries.

Step 7
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 01 13 AA 59 209 18

Step 2
Disconnect battery wires.

Step 5
After replacing the
batteries, put the battery
box back to original
location and screw it
tightly.
Put the front panel back to the unit.

Step 3
Pull out the battery box by
removing two screws on the
front panel.

Step 6
Re-connect the battery wires.
7