Machine Assembly; Instructions For Mounting Autofeed; Machine Inspection - RIDGID K-380 Manual Del Operador

K-380 Drain Cleaning Machine

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Drain Cleaner is required. The following procedures
should be followed:
Figure 1 – K-380 Drum Machine with

Instructions For Mounting Autofeed

1. Screw handle into the autofeed.
2. Place the mounting bracket onto the back of the
autofeed. Bracket shaft must be inserted into the
center hole of the autofeed while the two (2) holes in
the bracket must be aligned with the mounting pins
(Figure 2) .
Figure 2 – Placing Mounting Bracket Into Auto Feed
3. Attach autofeed onto the front frame of the K-380
using the two (2) / " x 1" flat head screws. Insert the
5
16
screws into the holes in the frame from the back
(Figure 3) . Be sure to use the lock washers and
tighten the screws until auto feed unit is secure. DO
NOT OVERTIGHTEN.
3 / " Cable and Tools
8
Ridge Tool Company
Figure 3 – Mounting Auto Feed Onto The Frame

Machine Inspection

WARNING
To prevent serious injury, inspect your Drain
Cleaning Machine. The following inspection pro-
cedures should be performed before each use.
1. Make sure the Drain Cleaning Machine is unplugged
and the directional switch is set to the OFF position
(Figure 4) .
2. Make sure the foot switch is present and attached to
the Drain Cleaning Machine (Figure 4) . Do not oper-
ate the machine without a foot switch.
Figure 4 – Directional Switch In OFF Position
5