Description, Specifications And Standard Equipment Description; Specifications; Standard Equipment - RIDGID K-750R Manual Del Usuario

K-750R
• Wear safety glasses and rubber soled, non-slip
shoes. Use of this safety equipment may prevent seri-
ous injury.
• Only use the K-750R to clean drain lines 3" to 6" in
diameter. Follow instructions on the use of the
machine. Other uses or modifying the drain cleaner for
other applications may increase the risk of injury.
Description, Specifications and

Standard Equipment

Description
The RIDGID K-750R Drain Cleaning Machine will clean
drain lines 3" to 6" in diameter and 100 feet in length. It
is specifically designed with a steel wire drum to allow for
inspection and cleaning of the cable.
The steel wire drum is belt-driven by a
motor that has a grounded electrical system. An integral
Ground Fault Interrupter (GFCI) is built into the line cord
and a "kickstand" base is provided for machine stability
during operation. A pneumatic foot actuator provides
ON/OFF control of the motor.
" inner core cable that has a quick
The drum powers a 5 /
8
change coupling system for connecting or disconnecting
tools. The cable is manually fed in and out of the drain. An
integral torque limiter will cause the drum to stop rotating
whenever excessive torque is created when the cutting tool
attached to the cable hits a snag and stops rotating.

Specifications

Line Capacity ...............3" – 6" Lines, Up To 100 feet
Drum Capacity .............100' of
Motor Type...................115V, Reversible, Single
Rating............................
Amps............................6.5
Weight
(Machine & Cable) ........194 lbs.
Length..........................26"
Width............................21"
Height ..........................43"
Standard Features
K-750R
• K-750R Cage Machine (Figure 1)
• C-24 IW Solid Core Cable (Integral Wound)
" x 100')
( 5 /
8
• 1 Pair Gloves
• T-403 P-Trap Cutter (Figure 2)
4
5 / " Cage Machine
8
1 / HP electric
2
" Cable
5 /
8
Phase, AC (60Hz)
1 / HP @ 1725 RPM
2
• T-406 Spade Cutter (Figure 3)
• T-411 2" Cutter (Figure 4)
• T-413 3" Cutter (Figure 4)
• T-414 4" Cutter (Figure 4)
• Safety & Instruction Card
• Rental Checklist Card
• Instruction Video
• Toolbox
Figure 1 – Machine With Gloves
Figure 2 – T-403 3" P-Trap Cutter: Used for exploring
and breaking up stoppages.
Figure 3 – T-406 Spade Cutter: Used to get soft grease
or debris moving in the drain.