Lap-Shoulder Belt Installation - Britax B-SAFE 35 Guia Del Usuario

BRITAX Child Safety, Inc.

Lap-Shoulder Belt Installation

IMPORTANT: Check your vehicle owner's manual to
determine how to lock your vehicle belt system.
* If you cannot lock your vehicle seat belt you must
use a locking clip. Locking clips are available from
BRITAX at 1-888-427-4829 or 1-704-409-1699.
1. Secure your child in the
infant car seat before
installing the car seat in
the vehicle.
2. Place the infant car seat
rear facing on the vehicle
seat.
3. Pull the vehicle belt out
and only route the lap
portion through the carrier
only belt guides.
4. Verify that the vehicle belt
is not twisted and buckle.
Lock your vehicle seat
belt system as instructed
by your vehicle owner's
manual.
22
5. Push the infant car seat
firmly into the vehicle seat
while removing all slack
from the lap portion and
then the shoulder portion
of the vehicle belt.
Carrier Only Installation with Lap-Shoulder Belt
CHECKLIST
ü Check that the vehicle belt is tight and that the
infant car seat is secure. The infant car seat is
secure when it moves less than 1 inch (2.5 cm)
front-to-back or side-to-side at the vehicle belt path.
ü Check that the recline angle is correct. The proper
recline angle is achieved when the level line on the
shell is level to the ground.
ü Check that the vehicle belt is not twisted and that it
is tight and locked.
ü Check that the infant car seat handle is rotated into
any locked position.
B-SAFE 35 User Guide
23