Troubleshooting - Pentair INTELLIBRITE CONTROLLER Guia De Instalacion

Powering on the IntelliBrite light(s)
When the IntelliBrite LED light is powered on, a momentarily white light will
illuminate, followed by the dial selected color.

Troubleshooting

Use the following tips to help to resolve problems that might occur while operating
the IntelliBrite Controller.
PROBLEM
Both of the
LEDs are
flashing
The light will
not illumi-
nate.
Light does
not function
properly.
Nonmetallic Outlet Box Specifications
The IntelliBrite Controller requires a specific nonmetallic outlet box. The outlet box
must meet the following specifications:
• Outlet box type: 19 cubic inches (minimum) - Suitable for wet locations
with UL/CSA approval listings. Check the inside of outlet box for
specification label.
650185 Gang Box Type Fss ¾ Dual Sckt Pvc
650186 Thd Adptr ¾ Spgt To ½ Npt Pvc
650187 Plug Hex Hd ½ Npt Sch80 Pvc Dark Gray
650189 Scr 6-32/1-1/2 Inch Oval Pth
522318 Lbl Door Intlbrt Cont 230V
522319 Lbl Data Warn Intlrt Cont 230V
The IntelliBrite Controller has detected that the load has exceeded
the maximum allowable wattage or the output is shorted out
1. Switch of the IntelliBrite Controller OFF.
Remove excessive load or short.
2. Press the IntelliBrite Controller power switch to power on
the unit. Ensure that the LEDs are no longer flashing.
Check the ground fault wiring and reset if necessary.
Check the light wiring connection to the junction box at the pool
side and to the main circuit breaker.
Be sure that there is proper AC power applied to the light
SOLUTION
6
Depth 61.6 cm (2.42")
Outlet Box
Length
115.3 cm
(4.54")
Width 71. cm (2.8")