Vogt HAMMER VH10 Manual De Instrucciones Original página 21

Attaching the double/cross blade holder and scraper to the
M 5000/M 5000.18 scraper holder:
Carriage bolt
cross blade holder
with cross blade
Scraper
CAUTION: beveled side below!
retaining lock nut
Mounting devices for double/cross blade holder
on scraper holder
2x carriage bolt, 2x retaining lock nut
Place double cross
blade holder and
scraper on the
scraper holder.
Assembling the B 55 cross blade:
Shoulder bolt screw
Cross blade holder
Cross blade
CAUTION: Danger of injury
Retaining lock shim
nut
Mounting devices Cross blade in Cross blade holder
1x Socket screw, 2x Retaining lock shim, 2x Nut
(by Double cross blade holder, order 2 x 902 017)
Insert the cross
blade into the
cross blade holder.
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de
Scraper must rest
on the edge
Insert carriage Screw on the wedge
screws. securing nuts by
hand.
Pat in with the The cross blade
hammer until the must lie flush
stop. against the scraper.
Scraperholder M 5000 / M 5000.18
902 004
902 005
902 016
Align the double
cross blade holder
parallel to the
scraper.
Shoulder bolt screw
Cross blade
Retaining lock shim
Nut
Double cross blade holder
Nut
Retaining lock shim
Cross blade
Socket screw
902 004
902 005
902 017
Insert the shoulder
bolt screw through the
cross blade and
cross blade holder.
Mounted:
Scraper with
cross blade holder
Scraper with
dounble cross
blade holder
Tighten with a
wrench.
Tighten with a
wrench
(10mm) and Allen
key (4mm).
Subject to change without notice
21
EN