Montaje Del Soporte Del Cono En El Alojamiento Del Cono - Vogt HAMMER VH10 Manual De Instrucciones Original

Attaching scrapers to the M 5000 scraper holder, assembly from below:
Retaining lock nut
Reinforcing sheet metal
(black plate)
from 160 mm wigth: large
Reinforcing sheet
Scraper
CAUTION: beveled side below!
Holding plate with pressed-in screws
Mounting devices 1x Holding plate, 1x Reinforcing sheet metal, 2x Retaining lock nut
Insert the holding
plate from below on to the threaded
through the scraper
holder.
10 Assembling the cone holder in the conical receiver
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de
Push the scraper Push the large
reinforcement plate
(160 scraper and
pins.
above) on to the
threaded pins.
• Insert the cone holder into the chisel holder.
• Insert the cone holder into the chisel receiver.
• Align the cone position with the T-handle
• Put the VOGT compressed air equipment into operation
(see Sections 3 and 4).
• Let the equipment run briefly, the cone holder will drive
itself in automatically
Scraper must rest Scraper holder M 5000 / M 5000.18
on the edge
902 020
Push the small Screw on the wedge
reinforcement plate securing nuts by
(black plate) on to hand.
the threaded plate.
Mounted:
Fertig montiert:
Scraper till 160 mm
Fertig montiert:
Schaber mit
Schaber
Umlenkvorrichtung
Scraper from 160 mm
Tighten with a
wrench.
Subject to change without notice
23
EN