WARNING: To ensure correct blade rotation,
always install the blade with the arrow printed on the
side of the blade indicating the same direction as the
arrow stamped on upper blade guard.
If you have taken out the inner flange (39) in order to
clean it, place it back as shown on Fig. 25.
Check that the retractable blade guard operates cor-
rectly and covers the blade as the saw arm is lowered.
Connect the saw to the power supply and run the blade
to make certain that it is operating correctly.
TRANSPORTATION
Prior to transporting the saw tighten securely the mitre
table lock handle (23), the bevel lock lever (32) and the
slide bar lock (30).
Shift the lock pin (31) to fold the head down. Block the
head by pulling out and rotating the lock pin (31) to 90º,
so it can enter its vertical groove. (Fig.26)
Use the transportation handle (11) to lift the saw. Do not
lift the saw by the operating handle!
MAINTENANCE
WARNING: Always ensure that the tool is
switched off and the plug is removed from the power
point before making any adjustments or maintenance
procedures. Always wear sturdy gloves when handling
or changing blades as they can be very sharp.
Keep the tool's air vents unclogged and clean at all times.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the trigger
switch. Use a soft brush to remove any accumulated
dust. Wear safety glasses to protect your eyes whilst
cleaning.
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid haz¬ards.
If the replacement of the supply cord is neces¬sary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
Re-lubricate all moving parts at regular intervals.
If the body of the saw needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used
10
EN
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.
IX - Warranty
The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
TKN 65