1.5 OTHER SAFETY RECOMMENDATIONS
For instruments of installation categories I and II, never work on
equipment that could generate voltage spikes (motors, etc.).
When measuring in the manual range, always start with the
maximum range and then select the most appropriate range.
First of all connect the black contact point and then the red one.
Disconnect the test leads before changing function.
First of all disconnect the red contact point and then the black one.
Use and install batteries that comply with the instructions in the
user's manual for the product you have purchased.
Check that there is no voltage present before using the
functions.
To measure voltage, to measure current:
Please read the safety recommendations before use.
To measure resistance, diode test, Continuity test, to measure
frequency / cycle ratio, to replace batteries and fuse.
To measure capacity there must be no voltage in the circuit and the
capacitor to be measured must be discharged.
The instrument is guaranteed against any material or manufacturing fault
in accordance with the General Sales Conditions. During the guarantee
period, the instrument may only be repaired by the manufacturer, who
reserves the right either to proceed to repair the product or replace it in
whole or in part. If any equipment is returned to the manufacturer, the
customer is responsible for paying the outward transport costs. The
guarantee does not apply in the case of:
Improper use of the instrument or its use with incompatible
equipment.
Modification of the instrument without express authorisation from
the manufacturer's technical departments.
Any work being performed on the instrument by anyone not formally
approved by the manufacturer.
Any adaptation for any particular application not provided for in the
instrument's definition or the operating instructions.
An impact, a fall or drenching in water.
Information and contact details for our After-Sales Services: contact
your distributor.
3. UNPACKING AND REPACKING
All the equipment has been checked mechanically and electrically before
dispatch. However, you are advised quickly to check for any damage
during transport. Should this be the case, inform the freight forwarder
immediately of your reservations. If you are sending anything back, please
use the original packaging and attach a note indicating the reason for the
return.
4.1 METROLOGICAL CHECKS
As with any measuring or testing instrument, periodic checking is required.
Information and contact details are available on request: Telephone (+33)
2.31.64.51.55 - Fax (+33) 2.31.64.51.09 or contact your distributor.
4.2 SERVICING
Periodically clean your multimeter with a cloth dampened with soapy
water. Do not use abrasives or solvents.
4.3 REPAIRS OUTSIDE METROPOLITAN FRANCE
For any work under or outside the guarantee, the instrument must be
returned to the distributor.
Remove the battery or batteries and store them separately if your
measuring instrument will not be used for more than 60 days.
2. GUARANTEE
4. MAINTENANCE
5. STORAGE
10
and Ω