Multimetrix CM 605 Manual De Instrucciones página 11

6.1 THE FRONT FACE
No. Function
1.
Black Negative COM terminal (-).
2.
Liquid crystal display 4 digits (9999 points).
'OL': current and voltage measurements exceed the
range.
3.
Trigger for opening the clamp.
4.
Guard: Your hand must be behind this protective guard.
5.
Movable jaws.
6.
Fixed jaws and gap. The conductor must be located in
the centre of this area during measurement for
maximum accuracy.
7. HOLD and PEAK buttons.
HOLD : This holds the measurement (Data Hold); the
Pressing the button again cancels the function.
PEAK : displays the peak value; the icone
displayed when the function is activated
for
cancels the function.
8.
Function rotary selector switch.
OFF : Multimeter off.
9. ZERO button. Measurement is considered as the zero
after button is depressed; the icon
Depress once more time to cancel.
10.
Red positive terminal (+).
6.2 THE DISPLAY
No. Function
11.
Negative value.
12.
Auto shutdown.
13.
Low batteries.
14.
AC/DC.
15.
Auto ranges.
16.
Relative
measurement.
17.
Peak value.
7.1 TO USE THE MULTIMETER
Set the selector (8) to any position other than OFF.
7.2 TO STOP THE MULTIMETER
Manual stop
Set the selector (8) to OFF.
Automatic shutdown
The multimeter shuts down automatically 30 minutes after the last
measurement.
Cancelling automatic shutdown
1. Set the selector (8) to OFF.
2. Hold down the ZERO button (9) and set the selector (8) to any
position other than OFF.
The icon disappears and automatic shutdown is deactivated.
Restarting automatic shutdown
1. Set the selector (8) to OFF.
2. Set the selector to any position other than OFF.
The icon appears and automatic shutdown is reactivated.
6. INTRODUCTION
icon appears when the function is activated.
. Press HOLD during 2 seconds
: AC current (100 A)
: AC current (100 A).
: AC voltage (600 V).
: DC voltage (600 V).
: Resistance and continuity (10 kΩ).
USE
No. Function
18.
Hold value.
19.
Continuity.
20.
Current.
21.
Voltage.
24.
Resistance.
25.
Reading.
7. USE
11
is
is displayed.