KPS MA20 Manual De Funcionamiento página 8

3. INTRODUCTION
NOTE: This device has been designed and tested according to the Item
IEC 348, Safety requirements for Electronic Measuring Devices, IEC-1010
(EN61010) and other security standards.
Follow all the instructions to be sure that the device is being safely used.
READ THE "NOTES ABOUT SECURITY" BEFORE USING THE DEVICE
4. NOTES ABOUT SECURITY
• Read carefully the following information about security before using the de-
vice.
• Use the device in the way this manual specifies, otherwise, the protection
offered by the device may be damaged.
• Specified environmental conditions:
1. Exclusive inside use
2. Installation category II.
3. Polution level 2
4. Altitude up to 2000 metres
5. Relative humidity 80% max.
6. Environmental temperature 0-40ºC
• It fulfils the requirements of the International Electric Symbols listed below.
The device is protected with a Double insulation or by a rein-
forced insulation.
Warning! Electric shock risk.
Caution! Refer to the manual before using this device.
~
AC current.
DC current.
• To avoid electrical shock, remove test loads before opening case.
• Do not exceed 750V AC in volt range.
KPS-MA20 • Insulation meter
WARNING
8