Messages On The Displays - SICE S 63 Manual De Instrucciones

programme
- Press the key
the selection. The "CAL" message will
appear on the left display, and one flash-
ing "E" will appear on the right one.
- Bring the automatic width measuring arm
into contact with the wheel contact flange
as shown in fig. 20.
- Press the key
sensor position;
- Return the arm to the rest position.
If the calibration has been performed suc-
cessfully, a consent message is displayed.
If the A20 message is displayed the me-
asuring device position is not correct for
calibration. Position it correctly, as descri-
bed above, and repeat the procedure.
By pressing the key
to exit the programme without executing
the calibration.
MESSAGES ON THE
DISPLAYS
The machine can recognise a certain
number of malfunction conditions and
70
illuminates.
twice to confirm
20
to confirm the
it is possible
signals them to the user by visualising the
relevant messages on the displays.
– A – Notice Messages
A 3 Wheel not suitable for perform-
ing the sensitivity calibration,
use a wheel of average dimen-
sions (typically 5.5"X1440") or
larger but with a weight that
does not exceed 40 kg.
A 5 Incorrect dimension settings for
an ALU programme. Correct the
set dimensions.
A 7 The machine is temporarily
unable to select the requested
programme.
Perform a wheel spin, then
repeat the request.
A 10 Internal sensor not in the rest
position. Return the sensor to
the rest position (completely
in). If the message does not
disappear, internal sensor
operation can be disabled by
pressing the
A 20 Sensor in an incorrect position
during calibration.
Bring it to the position indicated
and repeat the calibration.
A 23 Incomplete or incorrect data
entry in ALU P.
Repeat the input correctly.
A 26 Programme available only after
selecting one of the following
programmes: ALU 1P / ALU 2P
/ Motorcycle Dynamic / Motor-
cycle ALU or if selected in the
Motorcycle Programme but with
the wheel NOT in the centred
position.
A Stp
Wheel stop during the spin phase.
Wheel movement is not integral
with swinging unit movement:
Check correct wheel tightening.
button.
User manual S 63