SICE S 63 Manual De Instrucciones página 60

confirmation signal to indicate that the
distance and diameter values have been
acquired.
- Move the end of the automatic measuring
arm in correspondence with the plane
selected for the application of the outside
balancing weight (Fig. 14/14a), in the same
manner as described previously for the
inner side.
- Keep the arm in position and wait for the
acoustic confirmation signal.
- Return the measuring arm to the rest
position.
If the measuring arm is returned to the rest
position after acquiring the data relating
to only one plane or if first the outer plane
data then the inner plate data are acquired,
the "A 23" message is displayed and the
60
acquired data are not considered.
- Perform a spin
in the version with manual sensor, proceed
as follows:
- Press the key
machine for entering the distance d1
relative to the inner side (the distance
led will illuminate on the panel).
- Position the end of the measuring arm on
the plane chosen for the application of
the inner weight (Fig. 13/13a for ALU 1P
and Fig. 10/10a for ALU 2P). In Alu 1 P, the
centre of the pawl on the end section of
the lever is taken as a reference for the
centre line of the weight (version without
the weight holding device). In versions with
the weight holding device, the centre line
of the weight must correspond with the
centre of the groove in which the weight
14
will be placed. In Alu 2 P, the rim edge is
taken as a reference, since the inner weight
is of the conventional clip type.
Pay maximum attention when the end
of the arm is being placed in an area of
the rim free of discontinuity, so that the
weight can be applied in that position.
- Read the internal distance d1 from the
body on the rule.
- Modify the value on the right display by
pressing the
the previously measured distance d1.
14a
- Press the
the machine for entry of the d2 distance
relating to the outer side (the distance
LED lights up on the panel).
- Position the end of the measuring arm on
the plane chosen for the application of the
outer weight, as previously described for
the inner side.
- Read the distance d2 from the body on
to prepare the
keys to get
key again to prepare
User manual S 63