Deck Washing; Basic Maintenance Made Easy - IKRA IBRM 2351 TL Instrucciones De Manejo

23
3
3
3. Lift the side deflector guard and pull the attachment
off the rods to remove it.

Deck washing

(optional)
24
When the machine has stopped and is switched off:
- Connect the coupler (X) on the deck to the water-
supply tap.
- Turn on the tap.
- Switch on the engine (the blade should be spinning)
and let it run for a few minutes.
- When the machine is clean, switch off the engine.
Turn off the tap and remove the hose from the coupler.

Basic maintenance made easy

WARNING! If your mower is not serviced correctly,
you reduce your mower's ability to operate and
void warranty.
Maintenance schedule
Each use 25hours
of use
Air filter Check Clean
Spark Check Check
plug
Engine Check Check
oil
GB | Operating Instructions
(Fig. 24)
50hours 100 hours
of use of use
Clean Replace
Clean Replace
Replace Replace
Expert inspection is required:
a) If the lawn mower strikes an object.
b) If the motor stops suddenly
c) If the blade is bent (do not align!)
d) If the gears are damaged.
Replacing and resharpening the mowing blade at the
end of the mowing season always resharpen the mow-
ing blade or, if required, replace the mowing blade with
a new one. Always have the mowing blade resharpened
or replaced by a customer service centre (measurement
of imbalance).
Unbalanced blades will cause the lawn mower to vibrate
violently-risk of accident!
Change the blade
Caution: do not touch rotating blade
To remove the blade, unscrew the screw, check the
blade support and change all spare parts if they are worn
out or damage.
When reassembling the blade, make sure that the cut-
ting edges face in the direction of the engine rotation.
Engine oil replacement
1. Place the machine on even and stable surface. Warm
up the engine for several minutes and then stop it.
2. Loose the engine oil cap, the drain bolt and sealing
washer.
3. Drain oil into a container thoroughly by tilting the
engine toward the oil filler neck (fig. 18).
4. Once emptied, tilt the machine back and places it in
right position.
5. Refill with recommended oil to the upper limit of
the filler neck, and check oil level which should be
between the max. and min. level.
6. Reinstall the engine oil cap.
18
Change and clean the spark plug
1. Once the engine has cooled, remove the spark plug
using the spark plug wrench supplied.
2. Clean the plug with a wire brush.
3. Using a feeler gauge; set the gap to 0.6-0.7 mm (see
fig.19 & 20).
4. Install the spark plug carefully by hand, to avoid
cross-threading.
11