Archos DVR STATION Manual De Usuario página 16

DVR STATION
VERIFYING THE CHANNEL LIST
1. From the "
TV Control
2. This list was created from the channel line-up you selected during the TV Program Guide activation. Verify
that the channel list on the ARCHOS is the same as on your tuner.
3. Here you can deselect/select a channel or change the number of a channel.
SETTING THE INFRARED EMITTER
1 st Test: turning your tuner off
1. From the "
TV Control
the codes and parameters so that the ARCHOS can turn your tuner on/off automatically (for a scheduled
recording).
2. " ": select the type of tuner that you want to control with the IR Emitter ("
TV Receiver
", "
box Satellite Receiver
3. " ": choose the brand of your tuner. You can use the
Receiver brand
to scroll the list faster.
4. Select the "
Test power Off code
to turn your tuner off. After a few seconds, your ARCHOS will ask you if the device responded correctly:
If your tuner turned off, select "
If your tuner did not turn off, select "
ing a different code. Repeat this operation until the ARCHOS manages to turn the tuner off.
If none of the codes work, check that the DVR Station is positioned in a way that allows the infrared signal to reach your
tuner's receiver. Note: In some rare cases the ON/OFF functionality may not work.
14
" screen, select "
Set TV Channel List
• The DVR Station has a high-powered infrared LED, located on the front of
the device, at the same place as the remote control receiver.
• It allows your ARCHOS device to communicate with your tuner (VCR,
cable box, satellite receiver or Digital TV receiver), so that it can turn it on
and off, and change channels on it.
• This is a one time step to set your ARCHOS device to send the correct
infrared codes to control your tuner. If you do not plan on making sched-
uled recordings, then you do not need to set the infrared emitter code.
" screen, select "
Set Infrared Emitter
", " " or "
DVD Recorder Digital TV
" button. Make sure that your tuner is on. Your ARCHOS device will then try
", and move on to the next section.
Yes
No, try next code
".
". This first screen allows you to correctly set
").
buttons on the remote control
". Your device will try turning the tuner off again, us-
", "
VCR Cable/DSL