Waeco SinePower MSI912 Instrucciones De Montaje página 35

SinePower
 Do not operate the device in areas that are potentially explo-
sive.
 Maintenance and repair work may only be carried out by quali-
fied personnel who are familiar with the risks involved and the
relevant regulations.
 People (including children) whose physical, sensory or mental
capacities or whose lack of experience or knowledge prevent
them from using this product safely should not use it without the
supervision or instruction of a responsible person.
 Electrical devices are not toys
Always keep and use the device out of the reach of children.
2.2 Safety when installing the device
WARNING!
!
 Installing the device may only be performed by qualified person-
nel who are familiar with the guidelines and safety precautions
to be applied.
 If electrical devices are incorrectly installed on boats, corrosion
damage might occur. The device should be installed by a spe-
cialist (marine) electrician.
NOTICE!
A
 Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
 Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
 If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Fasten the cables securely.
 Lay the cables so that they cannot be tripped over or damaged.
EN
General safety instructions
35