Waeco SinePower MSI912 Instrucciones De Montaje página 48

Using the inverter
10.3 Configuring the inverter
NOTE
I
Settings can only be made using the dip switch if the S8 dip switch
is "On".
You can adjust the device using the dip switch (fig. 6 4, page 4 and
fig. 7 4, page 5).
Setting the mains voltage
You can set the mains voltage using the S1 and S2 dip switches.
Mains voltage
200 V
220 V
230 V
240 V
Setting the mains frequency
WARNING! Danger of electrocution
!
Only adjust the S3 DIP switch when the respective frequency for
the output voltage should be used.
You can set the mains frequency using the S3 dip switch.
Net frequency
50 Hz
60 Hz
Switching to energy-saving mode
You can set the energy-saving mode using the S4, S5 and S6 dip switches.
In this way, the battery you connect to the inverter is not discharged as quick-
ly.
48
Dip switch
S1
Off
On
Off
On
Dip switch
S3
Off
On
SinePower
S2
Off
Off
On
On
EN