Cleaning And Caring For The Inverter; Troubleshooting - Waeco SinePower MSI912 Instrucciones De Montaje

Cleaning and caring for the inverter

11 Cleaning and caring for the inverter
NOTICE!
A
Do not use sharp or hard objects or cleaning agents for cleaning as
these may damage the product.
➤ Occasionally clean the product with a damp cloth.
12

Troubleshooting

WARNING!
!
Do not open the device. You risk sustaining an electric shock by do-
ing this.
NOTE
I
If you have detailed questions on the specifications of the invert-
er please contact the manufacturer (addresses on the back of the
instruction manual).
The "Load Status" LED (fig. 6 3, page 4 and fig. 7 3,page 5) lights up red
to indicate the fault:
LED display
Quick flash
Slow flash
Occasional flash
50
Cause
Input voltage is too high
Input voltage too low
Overheating
Remedy
Check the input voltage and reduce
it.
The battery needs recharging.
Check the cables and connections.
Switch off the inverter and the con-
sumer.
Wait 5 to 10 minutes and switch the
inverter on again without any electric
consumers.
Reduce the load and make sure the
inverter has better ventilation. Then
switch the consumer back on.
SinePower
EN