SEVERIN KM3908 Instrucciones De Uso página 9

- when adding
attachments
- in case of any malfunction,
- aft er use,
- during cleaning.
 When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
 Caution: Any misuse can cause severe
personal injury.
 No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
 Th is appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural areas,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
 In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service
addresses can be found in the appendix to
this manual.
Before fi rst use
Remove any packing materials completely
and clean all accessories as described in the
section General care and cleaning.
Operating switch
Th e operating switch allows for the following
switch settings:
II Th e unit is switched on - high speed
I Th e unit is switched on - low speed
0 Th e unit is switched off
P With the switch held in this position:
On – high speed
Wind-up power cord storage
Th e power cord can be wound up for storage
on the underside of the unit. Unwind it
or removing any
departments. Th e
completely before operation.
Operation:
General information
– First, fi t the required attachment.
– Note: this kitchen appliance is equipped
with two safety switches and can only be
activated if the selected attachment has
been correctly fi tted and safely locked.
– Turn off the appliance aft er use (switch
position '0') and wait until the motor
has come to a complete standstill before
changing or removing any attachments.
Chopping/mincing and puréeing
– Fit the drive shaft to the drive unit.
– Attach the bowl with the handle to the
right and turn it clockwise to lock until
the lock symbol and triangular mark are
aligned.
– Fit the drive shaft extension to the drive
shaft .
– Remove the protective cover and fi t the
chopping/mincing blade to the drive shaft
extension in such a way that the blade
almost touches the bottom of the bowl.
– Caution: Hold the blade only by its plastic
shaft - the blades are extremely sharp.
– Put the ingredients (max. 700g) into the
bowl.
– Put the lid on the bowl and turn it
clockwise until it locks into place.
– For safety reasons, use the appropriate
pestle at all times when feeding the
ingredients down the food chute. During
operation, the pestle should remain
inserted.
Operation settings
We recommend using the switch setting P.
Th e right degree of chopping/mincing (from
coarse to fi ne) for meat, onions, dried fruit,
celery, fi sh etc. is normally achieved aft er 15-
30 seconds.
Puréeing
Th e bowl can be fi lled with a maximum
9