Fitting The Guides; Rebating Depth Guide (488543); Parallel Guide; Working With The Planer - Festool EHL 65 E Manual De Instrucciones

Rebating depth guide (488543)

The rebating depth guide (7.1) is mounted in the
threaded hole (7.2) on the front right of the ma-
chine.
The stop can be infi nitely adjusted to between 0
mm and 23 mm (0.9'') in accordance with the scale.
The rebating depth which has been set can be read
against the notch (7.3).
–
The surface to be planed must be free of metal-
lic objects.
–
First set the desired chip thickness.
–
Place The front platen onto The workpiece but do
not allow The planer head to come into contact
with The wood.
–
Switch on the planer.
–
Guide The planer over The workpiece so that The
platen rests fl at on The workpiece. Press on The
front planer platen when starting to plane and
on The rear planer platen (end of workpiece)
when continuing or fi nishing planing.

Fitting the guides

7.3
7.2
7.1

Working with the planer

8

Parallel guide

The parallel guide (8.4) is fi tted with a rotary knob
(8.2) in the threaded hole (8.1) on the left side of
the tool.
When planing along an edge a planing width of
between 0 mm and 65 mm (2.56'') can be set with
the stop after loosening the catch (8.3).
8.1
8.2
8.3
8.4

Chamfering

The front planer platen is equipped with a 90° V
groove (9.1) to allow the chamfering of workpiece
edges. This V groove is 2 mm (0.08'') deep, thus
producing a 2 mm (0.08'') edge chamfer with the
chip thickness setting 0.
9.1