Overheat Protection - AEG DG 5552 Instrucciones De Servicio

• You may also set the timer for the food to be
ready at a pre-set time.
• After the steamer has cooked for the set amount
of time, it will enter a keep-warm mode.
• Overheat protection: If the water is used up,
the device will turn off after some time.
Operating instructions
Instant steam function
1. Use the ON/OFF switch to turn on the device.
The display lights up blue.
2. Press SET button once. The display will show
the default setting of 5 minutes "00:05".
3. If you wish to steam cook longer than
5 minutes, set the cooking time by pressing
the minute button MIN repeatedly or the hour
button HR for 1 hour setting.
4. If the set cooking time is longer than
50 minutes, please refill with water during op-
eration before the 50 minutes have elapsed.
Otherwise the device will turn off.
Note:
►
The maximum time setting is 1 hour and
59 minutes.
►
During this process the readout "STEAMER"
will blink on the upper right of the display.
►
If you wish to change your input, press and
hold the respective button MIN or HR until
the desired values are displayed.
►
If no button is pressed within 5 seconds after
input, the device will start heating water auto-
matically. The readout "STEAMER" will then
illuminate steadily. The control lamp changes
from blue to red.
►
The timer counts down. When elapsed,
5 signal tones will alert you that the cooking
has been finished.
Delayed cooking
1. Use the ON/OFF switch to turn on the device.
The display lights up blue.
2. Press SET button once. The display will show
the default setting of 5 minutes "00:05".
3. Set the cooking time by pressing minute button
MIN repeatedly or hour button HR for 1 hour
setting.
4. Press SET button a second time.
5. Set the time for the device to start cooking, us-
ing the MIN and/or HR buttons.
Note:
►
During this process the readout "TIMER" will
flash on the upper right of the display.
►
You may delay cooking by maximum 12 hours
and 59 minutes.
Note:
►
If you wish to change your input, press and
hold the respective button MIN or HR until
the desired values are displayed.
►
If no button is pressed within 5 seconds after
input, the timer will automatically start to
count down. The readout "TIMER" will then
illuminate steadily. When the time of the TIM-
ER has elapsed, the device will automatically
turn to "STEAMER" mode and start cooking.
The control lamp changes from blue to red.
Warning:
Never operate the device unattended. When
setting the timer to delay cooking, set a time that
ensures operation with proper supervision.
Keep-warm mode
• After the cooking time has elapsed, a signal
tone will sound 5 times.
• The display will show the readout "00:00", and
below that "KEEP WARM".
• The control lamp will change from red to blue.
The keep-warm mode starts.
• The heater will turn on and off in intervals. Dur-
ing heating the control lamp will light up red.
• The device counts the minutes onwards. The
display will show the elapsed time during keep-
warm mode.
terminating operation
Press ON/OFF switch. The display turns off. All
settings will be reset.

Overheat protection

When the water is used up, the device will turn off
after some time. All settings will be reset. A signal
tone will sound. The display backlight and control
lamp will turn off.
Warning:
►
The device is still connected to the mains!
• Terminate operation by disconnecting the plug.
Or refill with cold water.
Note:
►
The device will always switch into standby
mode automatically after the heating element
has cooled down.
►
The control lamp lights up blue indicating its
operating state.
►
This procedure might take up to 30 minutes,
depending on whether or not you have
refilled with water.
eNGLIsh
49