Technical Data; Installation Instructions; Instructions For Care - Camargue 27179282 Instrucciones De Montaje

GB | Installation instructions
Dear customer,
You have purchased a high-quality and long-
lasting product from our line of goods. Please
read these instructions carefully before assem-
bling and observe the notes.Therefore, keep
the instructions in a safe place and pass them
on to possible subsequent owners.
Safety notes
• Only allow experts carry out the installation
work.
• CAUTION DAMAGE BY WATER!
Prior to installation please turn the general
water supply off.
• Ensure that all gaskets have the correct fit.
• These taps are not suitable for use on low
pressure and small electrical storage heaters.
• We recommend the installation of a filter
into the appliance or at least the use of angle
valves with filter, in order to avoid the inflow
of foreign matter, which could damage the
cartridge.
• This tap is only intended for use in private
households! Only suitable for use in rooms
with a temperature over 0 °C, when there is
danger of frost, sut off the water supply and
empty the tap.
• Take care when adjusting the warm water.
Danger of scalding!
• Incorrectly installed fittings can cause water
damages!
• Please ensure that no caustic or corrosive
products such as detergents or household
cleaning products make contact with the
connection hoses; this can lead to water
damages.
• Despite careful production, sharp edges can
occur. Please exercise caution!
Disposal
Your washbasin tap is delivered in a solid pack-
aging, in order to protect it against transport
damages. The packaging consists of recyclable
materials. Dispose it in an environmentally
suitable manner.
Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.

Technical data

• Flow pressure: Recommended as 1.5 to 6 bar;
in case of more than 6 bar connection pres-
sure, we recommend that a pressure reducer
is installed
• Water temperature: max. 80 °C

Installation Instructions

• Only hand-screw the connecting pipes, do
not use pliers or a wrench!
• After installing the tap please unscrew the
mixer nozzle, flush the pipeline and the tap
thoroughly for a longer time, in order to flush
out contaminations and residues.
• Do not twist or tension pipes! At first use
check connections for leaktightness!
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incor-
rect installation - in particular for subsequent
damages!

Instructions for care

Sanitary taps require special care. Therefore,
please observe the following instructions:
30