Intended Use; Description; Operator Responsibility - Safety Notes; Operator Responsibility - SI Analytics CK 300 Manual De Instrucciones

Intended use

Description

Operator responsibility – Safety notes

Operator responsibility

Intended use
The flow cooler CK 300/CK 310 cools liquid media (water, silicone oil or mineral
oil, ethanol and polyglycols).
Precise information about the bath media to be cooled and their operating
temperature can be found in Section 3.2 ("Tempering liquids") in this operating
manual.
The flow-through Cooler CK300/CK 310 are not suitable for direct cooling of foods,
semi-luxury foods and tobacco, or pharmaceutical and medical products.
Cooling means the unprotected contact of the object with the bath medium (bath
fluid).
The flow-through cooler CK300/CK310 cools down the liquid wich is pumped
through the built-in heat exchanger. Therefor, an external pump is required like
the one built-in the immersion circulators from SI Analytics GmbH
A typical application for the flow-through cooler CK300/CK310 is the usage in the
external liquid circuit of a transparent bath.
SI Analytics GmbH
The products of
operated, and maintained according to common safety regulations. This section
explains the potential dangers that may arise when operating the circulator and
also specifies the most important safety precautions to preclude these dangers
as far as possible.
Make sure all persons tasked with operating, installing, and maintaining the unit
have read and understand the safety information and operating instructions.
Set up, maintenance, repair
Only qualified personnel is authorized to perform configuration, installation,
maintenance and repairs of the thermostat.
Handling
Make sure the product is checked for proper condition regularly (depending on
the conditions of use).
ensure safe operation when installed,
17
.