Makita BFH040 Manual De Instrucciones página 7

Beeper
For models BFH040F/BFH090F/
BFH120F only
Also, Beeper on the tool shows the following functions.
Function
This function works when the tool has
reached the preset fastening torque and
Auto-stop fastening
normal tightening has been completed.
This helps overtightening to be avoided.
For approximately one second after
Delayed re-start auto-stop fastening, the tool does not
start even if the switch trigger is pulled.
Warning against Insufficient fastening has been performed
insufficient when the switch trigger has released before
fastening reaching the preset fastening torque.
Warning for This indicates the appropriate time to
battery cartridge replace the battery cartridge when the
capacity battery power becomes low.
Checking the This function works when the battery
remaining battery power is almost used up. At this time,
capacity, auto-stop tool stops immediately.
Operation error This function operates to indicate that
of the removing an incorrect battery removal operation
battery cartridge is being attempted.
This function works to check the proper
Check the LED
operation of the LED indicator, front lamp
indicator, front
and beeper when a battery cartridge has
lamp and beeper
been inserted into the tool and the interlock
operation
switch is lowered.
This function works when an abnormal
Anti-reset of
drop of the battery voltage occurs for
controller
some reason, and the tool stops.
This function works if the temperature of
Overheat the controller or moror increases to a high
level and the tool stops.
This indicates the abnormal condition of
Motor malfunction
the motor. The tool does not operate.
This indicates abnormality of interlock switch
Interlock switch
when the battery cartridge has been inserted.
malfunction
The tool does not function.
* For models BFH040F/BFH090F/BFH120F only
LED indicator/beeper
The LED indicator/beeper on the tool shows the following functions.
Status
Lights up in green for
approximately one
second.
Lights up in red.
Flickers in red slowly. A series of long beeps
Lights up in red.
Flickers in green
slowly.
Light up first in green,
next red(And then the
front lamp comes on.*)
Flickers in red and
green alternatively.
Flickers in red quickly.
Flickers in red and
green alternatively.
Flickers in red and
green alternatively.
Status of the LED indicator/beeper
LED indicator Beeper *
-
A long beep
A long beep
A series of long beeps.
A series of very
short beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
7 ENGLISH
Action to be taken
-
Retighten the screw
Replace the battery with
fully charged one
Replace the battery with
fully charged one
Release the switch trigger,
raise the interlock switch,
and then remove battery
cartridge.
-
Replace the battery with
fully charged one
Remove the battery
cartridge immediately and
cool the tool down.
Ask Makita service centers.
Ask Makita service centers.