Setting The Time Of Functioning - SOMFY RGB LED Receiver io Instrucciones

EN
2) Press the Up and Down buttons simultaneously on the 1W
io control point and follow procedure 2.2.1.1. or 2.2.1.2.
according to the reaction of the LED light(s).
2.2.1.1. An LED light comes on then goes out
Case 1: It is for this LED light that the control point must be programmed
• Briefly press the PROG button on this io control point.
The LED light comes on then goes out.
The io control point has been programmed for this LED light.
Case 2: It is not for this LED light that the control point must
be programmed
• Press the Up and Down again simultaneously on the 1W io control point and repeat if necessary
until the desired LED comes on then goes out.
͉
͉
If the output selected is not connected to any LED light, nothing
will come on. Select a different output.
• Briefly press the PROG button on this io control point.
The LED light comes on then goes out.
The io control point has been programmed for this LED light.
2.2.1.2. No LED light comes on
Press the Up button.
• If one or more LED lights come on:
The io control point has been programmed for the LED lights
lit.
- Go to section 2.3.
• If no LED light comes on:
check the status of the LED lights and the connection and try
again.
- Go to section 2.3.3.
2.2.2. Activating / deactivating automatic cut-off
͉
͉
Prerequisite: Commissioning has been completed using a 1W io control point.
This function allows an LED light to be switched off automatically after 3, 6 or 12 hours of operation.
It is possible to configure this period (see 2.2.3.).
The default setting for this function is deactivated.
The procedure to be followed to activate or deactivate automatic cut-off of each LED light is identical:
• Press the my and Down buttons simultaneously on the control point until the LED light comes
on then goes out.
- If the LED light comes on then goes out once: the function
is activated.
- If the LED light comes on then goes out twice: the function
is deactivated.

2.2.3. Setting the time of functioning

The operating period of each LED light before automatic cut-off can be configured.
6 Copyright © 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
RGB LED Receiver io
2.2.1.1.
2.2.1.2.
PROG.
PROG.
2.3.
2.3.3.