Earthing Instructions - Maytag Commercial MLE22PD Instrucciones De Instalación

STACKED WASHER/GAS DRYER INSTALLATION
Stacked Washer/Gas Dryer Electrical Requirements
IMPORTANT: Observe all governing codes and ordinances.
You will need an earthed electrical outlet located within 610 mm
(2 feet) of either side of the washer/dryer.
This washer/dryer is supplied/fitted with an electrical supply cord
and plug. It should be connected to electrical supply socket at
the voltage shown on the rating plate. The minimum supply fuse
capacity should be 10A. The washer/dryer must be positioned so
that the plug is clearly visible and accessible. This plug also provides
the function of an emergency stop control for the user. If the fitted
plug is not used, the electrical connection must be carried out by a
competent electrician in accordance with local or national codes.
If the supply cord is damaged, it must be replaced with a specially
terminated cord by an authorised service agent or a similarly
competent person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordance with the European EMC Directive (2014/30/
EU), the maximum electricity supply system impedance to which
the gas dryer should be connected is declared to be 0.054 Ohm +
j0.034 Ohm.
NOTE: Electrical safety standards: The manufacturer has chosen
compliance with IEC/EN 60335 standards as the most appropriate
for this product.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
bond path is adequate.
REQUIREMENTS

EARTHING INSTRUCTIONS

n For an earthed cord-connected dryer:
This dryer must be earthed. In the event of a malfunction or
breakdown, earthing will reduce the risk of electric shock by
providing a path of least resistance for electric current. This
dryer is equipped with a cord having an equipment-earthing
conductor and an earthing plug. The plug must be plugged into
an appropriate outlet that is properly installed and earthed in
accordance with all local codes and ordinances.
WARNING :
Improper connection of the equipment-
earthing conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative
or personnel if you are in doubt as to whether the dryer is
properly earthed. Do not modify the plug provided with the
dryer; if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
SAVE THESE INSTRUCTIONS
Using the universal cord included with this dryer:
The gas dryer is equipped with a universal cord with
interchangeable plugs.
1. To use the universal cord, select the plug end that fits your
electrical outlet, and plug it into the adapter on the supply cord.
2. Secure the plug end in place on the cord by aligning the two
cover halves over the cord adapter and clipping them together.
11