Playback Procedure; Status Display Of Dvd Disc - Sharp LC-19AD22U Manual De Operación

Watching the DVD
Playback procedure
0,s0 P,aces,o, the w,th d,s0 the '° t.e ,abe,
(If the disc has a
label ) Held the disc
without touching its
surface, align it with
the guides, and place
..... it in position,
at sdsp yo
St u i la fDVDdisc ....
Press DISPLAY The status display of the disc will
appear on the screen in order tike the figure below
ELAPSED TOTAL
D!SC OPERATION TIME TIME
TITLE NO
CHAPTER
-NO
On the screen, "_--."changes to "Reading"
and then playback will commence
,, A menu screen appear on the TV screen, if the
disc has a menu feature In this case, press
*/v/</_ or ENTER to operate a menu feature
ANGLE NO SUBTITLE LANGUAGE
AUDIO LANGUAGE A KIND OF AUDtO
If the TV/DVD does not operate properly:
Stalic electricity, etc, may affect the player's operation
Disconnect the AC power cord once, then connect it again
Press STOP to end playback
• The unit memorizes the stopped point,
depending on the disc 'I_' appears on the
screen Press PLAY to resume playback (from
the scene point).
= tf you press STOP again ("m" appears on the
screen) or unload the disc, the TViDVD will
clear the stopped point
Press EJECT
Remove the disc and then press POWER
The TV!DVD turns off
• When you ejectthe disc, you may hear
mechanism noise, but it is not malfunction
• If a non*compatible disc is loaded, "Incorrect Disc", "Region Cede Error" or "Parental Error" will appear on theTV screen
according to the type of loaded disc if these appear, check your disc again (see pages 5 and 49)
• Some discs may take a minute or so to start playback
• When an 8 cm disc is placed into the disc slot. and the playback picture or menu display does not appear, press PLAY
• A "Prohibition" symbol "X" may appear at the upper right of the screen This symbol means eilher the feature you tried is
not available on the disc, or the TV/DVD cannot access the feature at this time This does not indicate a problem with the
TV/DVD
• When you set a single-faced disc label downwards (i.e the wrong way up) "Reading" wilt appear on the display and then
"incorrect Disc" will be displayed.
• Some playback operations of DVDs may be intentionally fixed by software producers Since this TViDVD plays DVDs
according to the disc content recorded, some playback features may not be available Also refer to the instructions supp_Ied
with the DVDs
• Do not move the unit during playback. Doing so may damage the disc
,, Use EJECT to unload and eject the disc
• Do not put any objects other than discs on the disc slot. Doing so may cause the unit to malfunction
• In many instances, a menu screen will appear after playback of a movie is completed Prolonged display of an on-screen
menu may damage your television set, permanently etching that image onto its screen To avold this, be sure to press
POWER on your remote control once the movie is completed
• There may be a sfight delay between the button is pressed and the function activates
(_ 37