Spare Parts Service; Warranty Conditions; Reach - Schneider Airsystems KAL-Ecomat 3100 Manual De Instrucciones

D
Ecomat 3100
Problem
B Test button
pressed but con-
densate not dis-
charged
C Condensate
only discharged
when the test
button is pressed
D Condensate dis-
charger blows out
continuously
If necessary, contact our service staff, see last page.
12

Spare parts service

Visit our website
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.
13

Warranty conditions

Basis for warranty claims: complete unit
in original condition/proof of purchase.
According to legal provisions, you re-
ceive the following warranty against
material and manufacturing defects:
private use only: 2 years,
commercial use: 1 year.
10
Cause
Inlet and drain line
shut off / blocked
Wear
Metal blank faulty
Condensate discharge
block faulty
Pressure below
min. value
Pressure above
max. value
is Inclination of condensate
inlet line too small
Cross section of conden-
sate inlet line too small
Excessive amount of con-
densate
Condensate discharge
block extremely dirty
Condensate discharge
block faulty / dirty
www.schneider-airsys-
Remedy
Check inlet and drain line.
Check whether the valve audibly opens
(press the test button several times).
Have the metal blank checked for dam-
age. Contact Schneider Druckluft Service.
Check voltage value on type plate.
Replace the condensate discharge block.
Check the operating pressure
(min. 0.8 bar / max. 16 bar).
Install condensate inlet line with steeper
inclination.
Use condensate inlet line with larger cross
section.
Install an air compensation line.
Replace the condensate discharge block.
Replace the condensate discharge block.
The following are excluded from the
warranty: wear parts and damage caused
by improper use, incorrect electrical connec-
tion, insufficient / no maintenance, improper
installation, dust accumulation.
14

REACh

REACh is a European Chemical Directive that
came into effect in 2007. As "downstream
users" and product manufacturers, we are
aware of our duty to provide our customers
with information. We have set up the follow-
ing website to keep you updated with all the
latest news and provide you with information
on all the materials used in our existing prod-
ucts:
www.schneider-airsystems.com/reach