B.Braun Aesculap VetCare Instrucciones De Manejo página 15

If used regularly, the blade set 5 should be thoroughly
cleaned once a day.
Switch the appliance off.
Remove the comb attachment if fitted.
Use the cleaning brush 12 to remove any hairs.
Oiling the blade set
To maintain the high-quality cutting performance of the
blade set as long as possible, it must be oiled regularly –
preferably daily.
Remove the comb attachment if
fitted.
Lubricate the areas where there
is contact between the upper and
lower parts of the blade set (see
illustration).
Replacing the blade set
The blade set is subject to wear. Even if you look after the
appliance properly, the cutting performance will deteri-
orate. Replace the blade set when it is worn. The blade
set can be ordered separately as a spare part from
Aesculap Customer Service (see addresses at the end of
these instructions).
Damage to casing when screwing on
clipper head!
Do not over tighten the screw.
WARNING
Make sure the On/Off switch 4
is in the 0 position.
Remove the Allen key 13 from
the base of the charging unit
and use it to loosen the blade
set screw 6.
Loosen the screw fully and re-
move it.
Push the blade set upwards with
your thumb.
Push the new blade set on until
it snaps into place and secure it
using the screw.
15