Publicidad
Idiomas disponibles
Idiomas disponibles
Front-
Phase 1
arm :
Extender
of the
wrist and
Phase 2
fingers
Forearm
Front-
28mn
arm :
Phase 3
Bender
of the
wrist and
fingers
Phase 4
Phase 1
Phase 2
Resistance
Hip
of the hip
32mn
muscle
Phase 3
Phase 4
Phase 1
Phase 2
Resistance
of the
Thigh
28mn
hamstring
Phase 3
muscle
Phase 4
42
BewellConnect - BW-TS1 - User Manual - 072015
Preparation
5Hz (5mn)
300
phase
Intensity :
50%
55Hz (10s)
200
Up : 1,5s
Down :
0,75s
EMS
Intensity:
6Hz (8s)
200
25%
Phase of
relaxation
3Hz (10mn)
200
Intensity :
40%
Preparation
5Hz (5mn)
300
phase
Intensity :
50%
75Hz (6,3s)
300
Up : 1,5s
Down :
0,75s
EMS
Intensity:
4Hz (8s)
300
25%
Phase of
relaxation
3Hz (10mn)
300
Intensity :
40%
Preparation
5Hz (5mn)
370
phase
Intensity:
50% Up:
55Hz (10s)
370
1.5s Down:
0.75s
EMS
Intensity:
6Hz (8s)
370
25%
Phase of
relaxation
3Hz (10mn)
370
Intensity:
40%
Phase 1
Phase 2
Resistance
Lower leg
of the calf
28mn
muscles
Phase 3
Phase 4
Training
Foot
30mn
Phase 1
the foot
4.4. INDICATIONS BEFORE USE
Charging the device
Firstly charge the device before use. In normal times (ambient temperature), it takes 5 hours
to charge the device. A full charge allows a battery life of about 8 hours continuously when
functioning in normal conditions. Please charge the device fully before beginning a session. If
the charge is not complete at the beginning of a programme, the battery may become deplete
before the end of the session. You cannot use the device when it is on charge.
See Schema B page 2
1. Disconnect the cable used to connect the two units of the micro-USB of the unit with the
battery light .
2. Insert the micro-USB cable into the micro-USB socket for the respective unit .
3. Insert the USB plug into a computer to charge the device.
4. When the battery light goes into continuous orange (which means that the battery is be-
ing charged) to a continuous green (the battery is full), remove the micro-USB plug from the
micro-USB socket of the unit with the battery indicator (see diagram 4). Use the USB plug only
for the use described above (to charge and connect to the cable connecting the two units).
5. Reconnect the cable connecting the two units : Insert the connector of this cable into the
micro-USB socket for the unit with the battery light .
BewellConnect - BW-TS1 - User Manual - 072015
Preparation
5Hz (5mn)
370
phase
Intensity:
50% Up:
55Hz (10s)
370
1.5s Down:
0.75s
EMS
Intensity:
6Hz (8s)
370
25%
Phase of
relaxation
3Hz (10mn)
370
Intensity:
40%
Up : 2s
Con : 8s
50Hz
200
EMS
Down : 2s
Rest : 4s
43
Publicidad
