Helpful Hints - THERM PRO TP-20 Manual De Instrucciones

reaches 0'00" the timer starts counting up and it will beep for 60 seconds.
Press any button to stop the timer.
Count up
1. Press the MODE button to select the TIMER mode, The timer 00:00
with a small icon TIMER will be shown in the upper part of the display.
If the timer setting is not 00:00, press and hold S./S./
EN
clear the setting to 00:00.
2. Press the S./S./ /CLEAR
blink indicating count up timer is running. The maximum count up that
can be reached is 99 hours and 59 minutes.
3. To stop the count up process, press the
▲ ▲
TIMER becomes solid.
4. Press and hold S./S./ /CLEAR
5. When count up timer reaches 59 minutes and 59 seconds, it will
automatically change to Hour: Minute display format.

Helpful Hints

If the receiver and / or the transmitter display LLL or HHH instead of
the probe temperature, wait for probe to reach room temperature. If
LLL or HHH is still displayed or you get a false temperature, squeeze
the probe jacks harder into the transmitter and twist them back and
forth so they make good contact. If the problem still persists, it is likely
the internal probe wire has shorted out either through moisture or heat
damage.
Do not immerse the probe in water while cleaning.
Do not allow the probe or probe wire to come into contact with flames.
Within the warranty period return defective probe to address below
along with a return address and we will send you a replacement probe
at no charge.
If the temperature displayed seems to read too high or the temperature
seems to increase too quickly, check to make sure the probe tip is not
poking through the food. Reposition the probe tip in the center of the
thickest part of food. Avoid touching bone or heavy fat areas.
/CLEAR to
button to start count up. The TIMER
S./S./ /CLEAR button. The
to clear the setting back to 00:00.
-10-
Cautions:
1. Always wear a heat resistant glove to touch the stainless steel probe
sensors or wires during or just after cooking. Do not touch with bare
hands.
2. Keep the stainless steel probe sensors and wires away from children.
3. Clean the stainless steel probes and dry thoroughly after each and
every use.
4. Do not use the unit in the rain. It is NOT rain proof.
▲
will
5. Do not expose the plugs of the stainless steel probes or the plug in
holes of the transmitter to water or any liquid. This will result in a bad
connections and faulty readings.
6. Do not expose the receiver or transmitter to direct heat.
7. Do not use stainless steel probes in a microwave oven.
8. The Probe Thermometer registers temperatures as low as 32 ºF (0 ºC)
and as high as 572 ºF (300 ºC). LLL will be displayed below 32 ºF and
HHH will be displayed above 572 ºF. Do not use the stainless probe
sensor above 572 ºF. Doing so will deteriorate the wire.
9. Not Intended for use by persons aged 12 and under.
Cleaning
1. Always wear a heat resistant glove to touch the stainless steel probe
sensors or wires during or just after cooking. Do not touch with bare
hands.
2. Keep the stainless steel probe sensors and wires away from children.
3. Wash the metal probe tips with hot soapy water and dry thoroughly. Do
not immerse the probe in water while cleaning.
4. Wipe the transmitter and receiver with damp cloth. Do not immerse
either in water.
-11-
EN