IKRA GBS 9054 LI Instrucciones De Manejo página 17

The start of the charging process is indicated by the red
control light ("X", Fig. 3) at the end of the handle. If the
battery is completely empty the charging time is about
3-5 hours. After the battery has been fully charged, the
electronic control automatically switches off the charging
process. The red control light then changes its colour to
green indicating the end of the charging process. It is not
required to monitor the charging time.
The charging unit and the handle of the tool heat up dur-
ing the charging process. This is nothing unusual.
Pull the plug of the charging unit if it is not in use.
The tool must never be switched on during the charging
process!
Recharge the battery every time you realise a consider-
able decrease of the tool's cutting performance. The
battery additionally features an electronic total discharge
protection that protects the battery from damage. This
feature switches the battery off if the discharging thresh-
old is reached. Do not switch the tool on afterwards and
make sure to recharge the battery first.
Switching the tool on/off
4
Slide the switch-on lock A (fig. 4) forward and push
switch B. After the tool has been switched on, you do not
have to hold the switch-on lock A any longer.
To switch off just let go of the switch B.
Attention! The blades will coast for a certain
time after switch-off!
Refitting the tool / Changing the shear sys-
tems
GB | Operating Instruction
A
B
5
Put the included blade guard into the blade(s) and use
protective gloves to protect yourself from injury.
Push both lateral push buttons concurrently and remove
the shearing blades (Fig. 5).
6
3
Remove any dirt from the gear area (if necessary).
Please slightly grease the drive area using commercial
universal grease as described in the Maintenance sec-
tion before putting the replacement shears in place
(Fig. 8).
7
2
1
1